Free Rhode Island Department Lead Inspector Examination Practice Questions

Sample Practice Questions

Try these 10 sample questions from the Rhode Island Department Lead Inspector Examination practice bank. Each includes the answer and explanation. Continue with the interactive practice above to review the full question set.

1. 1Before applying for an initial Rhode Island Lead Inspector-in-Training license, which examination must an otherwise qualified applicant pass?

   1. A. The Department Lead Inspector examination
   2. B. The Department Lead Supervisor examination
   3. C. The Lead Assessor course examination
   4. D. The Lead Renovator course examination

   Answer: A

   Explanation: Rhode Island requires the license-specific state exam: "The Department Lead Inspector examination passed by the applicant." The other listed examinations belong to different disciplines or to provider training.

   Reference: Lead Training, Certification and Licensing (216-RICR-50-15-11) - Rhode Island Department of State — § 11.7.4(A)(3)

2. 2Which Rhode Island inspection type is a surface-by-surface investigation of paint, dust, soil, and water?

   1. A. Comprehensive Environmental Lead Inspection
   2. B. Renewal Inspection
   3. C. Partial Lead Inspection
   4. D. RRP Clearance Inspection

   Answer: A

   Explanation: Rhode Island defines a CELI as "a surface-by-surface investigation ... to determine the presence of lead in paint, dust, soil, and water."

   Reference: Recheck Part 5 20261012 — § 5.2(A)(10)

3. 3For an initial Rhode Island lead inspection, where should floor dust wipes be targeted?

   1. A. Worst-case locations such as entries, high-traffic areas, beneath windows, and areas children use often
   2. B. A random location centered in every room
   3. C. Only rooms with visible paint chips
   4. D. Only pathways used for waste removal

   Answer: A

   Explanation: The rule requires a "worst case" approach, identifying entries, high-traffic areas, locations under windows, and areas frequently used by children.

   Reference: Recheck Part 5 20261012 — § 5.7.3(A)(1)

4. 4A Rhode Island Lead Inspector completes XRF calibration verification checks during an inspection. In which record must the results appear?

   1. A. Lead inspection report
   2. B. XRF Performance Characteristic Sheet
   3. C. Sample chain-of-custody form
   4. D. Laboratory analytical report

   Answer: A

   Explanation: The current rule says the "results of all calibration verification checks for a lead inspection must be recorded in the lead inspection report." The other choices are real technical records, but none is the state-designated record for these results.

   Reference: Recheck Part 5 20261012 — § 5.7.2(D)(5)

5. 5At what point does Rhode Island require the license-specific Department examination for an initial Lead Inspector-in-Training applicant?

   1. A. Before submission of the initial license application
   2. B. Within seven days after the license is issued
   3. C. After completing the supervised apprenticeship
   4. D. At the first biennial renewal

   Answer: A

   Explanation: The rule states applicants "shall pass a license-specific Department examination prior to submission of an initial license application." The exam is therefore an entry requirement, not a post-license or renewal event.

   Reference: Lead Training, Certification and Licensing (216-RICR-50-15-11) - Rhode Island Department of State — § 11.4.5(A)

6. 6Which inspection type may be limited to selected rooms or to only paint, dust, soil, or water?

   1. A. Partial Lead Inspection
   2. B. Comprehensive Environmental Lead Inspection
   3. C. Renewal Inspection
   4. D. Lead Hazard Mitigation Inspection

   Answer: A

   Explanation: A Partial Lead Inspection "may be limited to certain rooms/areas or media (paint, dust, soil, or water)." A CELI is comprehensive rather than limited.

   Reference: Lead Inspections (216-RICR-50-15-5) - Rhode Island Department of State — § 5.3(E)(2)

7. 7Which location set must dust-wipe sampling cover during a Rhode Island clearance inspection?

   1. A. Work areas, adjacent areas, access pathways, and waste-removal pathways
   2. B. Only the room where the largest paint area was disturbed
   3. C. Only exterior entry doors and play areas
   4. D. Only bedrooms and living rooms

   Answer: A

   Explanation: For clearance, dust wipes must be collected "in work areas, adjacent to work areas, as well as pathways used to access work areas and pathways used to remove waste."

   Reference: Recheck Part 5 20261012 — § 5.7.3(A)(2)

8. 8How may Rhode Island classify the physical coverage of a Clearance Inspection?

   1. A. Whole unit or worksite only
   2. B. Selected rooms or selected environmental media
   3. C. Surface-by-surface across all required media
   4. D. A biennial certificate-renewal evaluation

   Answer: A

   Explanation: The regulation states: "A Clearance Inspection may be a “whole unit” or “worksite only” inspection." The other choices describe features of partial, comprehensive, or renewal inspections.

   Reference: Recheck Part 5 20261012 — § 5.3(C)(2)

9. 9Who may handle registration for a Rhode Island Department lead-professional examination?

   1. A. The Department or its third-party vendor
   2. B. Only an accredited training provider
   3. C. Only the Housing Resources Commission
   4. D. The analyzing laboratory selected by the applicant

   Answer: A

   Explanation: The rule says applicants "shall register for the examination with the Department" and continues by allowing its third-party vendor as the other registration channel. A course provider, HRC, or laboratory is not identified as the registration authority.

   Reference: Lead Training, Certification and Licensing (216-RICR-50-15-11) - Rhode Island Department of State — § 11.4.5(B)

10. 10A property needs to determine whether the RRP Rule applies to painted surfaces. Is that a recognized purpose for a Rhode Island lead inspection?

    1. A. Yes, determining RRP applicability is an expressly listed purpose
    2. B. No, only a Lead Supervisor may make that determination
    3. C. No, a lead inspection may address certificates only
    4. D. Yes, but only after a failed clearance inspection

    Answer: A

    Explanation: The rule lists as a purpose: "To determine the applicability of the Renovation, Repair, and Painting (RRP) Rule."

    Reference: Recheck Part 5 20261012 — § 5.1.2(A)(1)(a)